관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
분야 | 05.01 : 석유제품 및 윤활유 (Ⅰ) |
---|---|
적용범위 | 1.1?This test method specifies a procedure for the determination of the kinematic viscosity, ν, of liquid petroleum products, both transparent and opaque, by measuring the time for a volume of liquid to flow under gravity through a calibrated glass capillary viscometer. The dynamic viscosity, η, can be obtained by multiplying the kinematic viscosity, ν, by the density, ρ, of the liquid. Note 1:?For the measurement of the kinematic viscosity and viscosity of bitumens, see also Test Methods D2170 and D2171. Note 2:?ISO 3104 corresponds to Test Method D445???03. 1.2?The result obtained from this test method is dependent upon the behavior of the sample and is intended for application to liquids for which primarily the shear stress and shear rates are proportional (Newtonian flow behavior). If, however, the viscosity varies significantly with the rate of shear, different results may be obtained from viscometers of different capillary diameters. The procedure and precision values for residual fuel oils, which under some conditions exhibit non-Newtonian behavior, have been included. 1.3?The range of kinematic viscosities covered by this test method is from 0.2?mm2/s to 300?000?mm2/s (see Table A1.1) at all temperatures (see 6.3 and 6.4). The precision has only been determined for those materials, kinematic viscosity ranges and temperatures as shown in the footnotes to the precision section. 1.4?The values stated in SI units are to be regarded as standard. The SI unit used in this test method for kinematic viscosity is mm2/s, and the SI unit used in this test method for dynamic viscosity is mPa·s. For user reference, 1 mm2/s = 10-6?m2/s = 1 cSt and 1 mPa·s = 1 cP = 0.001 Pa·s. 1.5?WARNING?Mercury has been designated by many regulatory agencies as a hazardous substance that can cause serious medical issues. Mercury, or its vapor, has been demonstrated to be hazardous to health and corrosive to materials. Use Caution when handling mercury and mercury-containing products. See the applicable product Safety Data Sheet (SDS) for additional information. The potential exists that selling mercury or mercury-containing products, or both, is prohibited by local or national law. Users must determine legality of sales in their location. 1.6?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
국제분류(ICS)코드 |
75.080 : 석유제품 일반
17.060 : 체적. 중량. 밀도. 점도의 측정 |
페이지수 | 16 |
Edition | 24 |
No. | 표준번호 | 표준명 | 발행일 | 상태 |
---|---|---|---|---|
1 | ASTM D445-24 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2024-04-01 | 표준 |
2 | ASTM D445-24 REDLINE | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2024-04-01 | 표준 |
3 | ASTM D445-23 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2023-11-01 | 구판 |
4 | ASTM D445-23 REDLINE | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2023-11-01 | 구판 |
5 | ASTM D445-21 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2021-05-15 | 구판 |
6 | ASTM D445-21e1 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2021-05-15 | 구판 |
7 | ASTM D445-21e2 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2021-05-15 | 구판 |
8 | ASTM D445-21 REDLINE | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2021-05-15 | 구판 |
9 | ASTM D445-19a | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2019-12-01 | 구판 |
10 | ASTM D445-19a REDLINE | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2019-12-01 | 구판 |
11 | ASTM D445-19 REDLINE | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2019-06-01 | 구판 |
12 | ASTM D445-19 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2019-06-01 | 구판 |
13 | ASTM D445-18 REDLINE | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2018-11-01 | 구판 |
14 | ASTM D445-18 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2018-11-01 | 구판 |
15 | ASTM D445-17a | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2017-05-01 | 구판 |
16 | ASTM D445-17 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2017-01-01 | 구판 |
17 | ASTM D445-16 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2016-12-15 | 구판 |
18 | ASTM D445-15a | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2015-12-01 | 구판 |
19 | ASTM D445-15 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2015-02-01 | 구판 |
20 | ASTM D445-14a | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2014-12-15 | 구판 |
21 | ASTM D445-14e1 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2014-07-01 | 구판 |
22 | ASTM D445-14e2 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2014-07-01 | 구판 |
23 | ASTM D445-14 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2014-07-01 | 구판 |
24 | ASTM D445-12 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2012-04-15 | 구판 |
25 | ASTM D445-11a | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2011-05-01 | 구판 |
26 | ASTM D445-11 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2011-01-01 | 구판 |
27 | ASTM D445-10 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2010-10-01 | 구판 |
28 | ASTM D445-09 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2009-07-01 | 구판 |
29 | ASTM D445-06 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) | 2006-05-15 | 구판 |
30 | ASTM D445-04e2 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and the Calculation of Dynamic Viscosity) | 2004-11-01 | 구판 |
31 | ASTM D445-04e1 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and the Calculation of Dynamic Viscosity) | 2004-11-01 | 구판 |
32 | ASTM D445-04 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and the Calculation of Dynamic Viscosity) | 2004-05-01 | 구판 |
33 | ASTM D445-03 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (the Calculation of Dynamic Viscosity) | 2003-03-10 | 구판 |
34 | ASTM D445-97 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (the Calculation of Dynamic Viscosity) | 2001-01-10 | 구판 |
35 | ASTM D445-01 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (the Calculation of Dynamic Viscosity) | 2001-01-10 | 구판 |
36 | ASTM D445-88 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and the Calculation of Dynamic Viscosity) | 구판 | |
37 | ASTM D445-74 | Standard Test Method for Kinematic Viscosity Of Transparent And Opaque Liquids (And The Calculation Of Dynamic Viscosity) | 구판 | |
38 | ASTM D445-65 | Standard Method Of Test For Viscosity Of Transparent And Opaque Liquids (Kinematic And Dynamic Viscosities) | 구판 | |
39 | ASTM D445-94e1 | Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (the Calculation of Dynamic Viscosity) | 구판 |
관련상품이 존재하지 않습니다.
ASTM D6749-24 - Standard Test Method for Pour Point of Petroleum Products (Automatic Air Pressure Method) 상세보기
ASTM D6371-24 - Standard Test Method for Cold Filter Plugging Point of Diesel and Heating Fuels 상세보기
ASTM D86-23ae1 - Standard Test Method for Distillation of Petroleum Products and Liquid Fuels at Atmospheric Pressure 상세보기
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기