관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
표준
판매
Standard Test Method for Estimation of Net Heat of Combustion of Aviation Fuels
| 분야 | |||||||||
|---|---|---|---|---|---|---|---|---|---|
| 적용범위 | 1.1 This test method covers the estimation of the net heat of combustion (megajoules per kilogram or [Btu per pound]) of aviation gasolines and aircraft turbine and jet engine fuels in the range from 40.19 MJ/kg to 44.73 MJ/kg or [17 280 Btu/lb to 19 230 Btu/lb]. The precision for estimation of the net heat of combustion outside this range has not been determined for this test method. 1.2 This test method is purely empirical and is applicable to liquid hydrocarbon fuels that conform to the specifications for aviation gasolines or aircraft turbine and jet engine fuels of grades Jet A, Jet A-1, Jet B, JP-4, JP-5, JP-7, and JP-8. Note 1: The experimental data on heat of combustion from which the Test Method D3338 correlation was devised was obtained by a precision method similar to Test Method D4809. Note 2: The estimation of the net heat of combustion of a hydrocarbon fuel is justifiable only when the fuel belongs to a well-defined class for which a relation between heat of combustion and aromatic and sulfur contents, density, and distillation range of the fuel has been derived from accurate experimental measurements on representative samples of that class. Even in this case, the possibility that the estimates may be in error by large amounts for individual fuels should be recognized. The fuels used to establish the correlation presented in this method are defined as follows: Fuels: Aviation gasoline—Grades 100/130 and 115/145 (1, 2)2 Kerosines, alkylates, and special WADC fuels (3) Pure hydrocarbons—paraffins, naphthenes, and aromatics (4) Fuels for which data were reported by the Coordinating Research Council (5). Note 3: The property ranges used in this correlation are as follows: Aromatics—from 0 % by mass to 100 % by mass API Gravity—from [25.7° to 81.2°API] Volatility—from [160 °F to 540 °F], average boiling point 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3.1 Although the test method permits the calculation of net heat of combustion in either SI or inch-pound units, SI units are the preferred units. 1.3.2 The net heat of combustion can also be estimated in inch-pound units by Test Method D1405 or in SI units by Test Method D4529. Test Method D1405 requires calculation of one of four equations dependent on the fuel type with a precision equivalent to that of this test method. Test Method D4529 requires calculation of a single equation for all aviation fuels with a precision equivalent to that of this test method. Unlike Test Method D1405 and D4529, Test Method D3338/D3338M does not require the use of aniline point. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||
| 국제분류(ICS)코드 | |||||||||
| 페이지수 | 5 | ||||||||
| Edition | 20 |
| No. | 표준번호 | 표준명 | 발행일 | 상태 |
|---|---|---|---|---|
| 1 | ASTM D3338/D3338M-20 REDLINE | Standard Test Method for Estimation of Net Heat of Combustion of Aviation Fuels | 2020-05-15 | 표준 |
| 2 | ASTM D3338/D3338M-20 | Standard Test Method for Estimation of Net Heat of Combustion of Aviation Fuels | 2020-05-15 | 표준 |
| 3 | ASTM D3338/D3338M-09(2014)e2 | Standard Test Method for Estimation of Net Heat of Combustion of Aviation Fuels | 2014-05-01 | 구판 |
| 4 | ASTM D3338/D3338M-09(2014)e1 | Standard Test Method for Estimation of Net Heat of Combustion of Aviation Fuels | 2014-05-01 | 구판 |
| 5 | ASTM D3338/D3338M-09(2014) | Standard Test Method for Estimation of Net Heat of Combustion of Aviation Fuels | 2014-05-01 | 구판 |
| 6 | ASTM D3338/D3338M-09 | Standard Test Method for Estimation of Net Heat of Combustion of Aviation Fuels | 2009-04-15 | 구판 |
관련상품이 존재하지 않습니다.
ASTM D512-23 - Standard Test Methods for Chloride Ion In Water 상세보기
ASTM D976-21e1 - Standard Test Method for Calculated Cetane Index of Distillate Fuels 상세보기
ASTM D7153-22ae1 - Standard Test Method for Freezing Point of Aviation Fuels (Automatic Laser Method) 상세보기
ASTM D7371-14(2022) - Standard Test Method for Determination of Biodiesel (Fatty Acid Methyl Esters) Content in Diesel Fuel Oil Using Mid Infrared Spectroscopy (FTIR-ATR-PLS Method) 상세보기
ASTM D1426-15(2021)e1 - Standard Test Methods for Ammonia Nitrogen In Water 상세보기
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기
KS표준
핸드북
