관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
분야 | ISO/TC 146/SC 3 : Ambient atmospheres |
---|---|
적용범위 | ISO 22262-3:2016 is primarily intended for quantitative analysis of samples in which asbestos has been identified at estimated mass fractions lower than approximately 5 % by weight. ISO 22262-3:2016 extends the applicability and limit of detection of quantitative analysis by the use of simple procedures of ashing and/or acid treatment prior to XRD quantification. ISO 22262-3:2016 is applicable to the asbestos-containing materials identified in ISO 22262‑1. The following are examples of sample matrices: a) any building materials in which asbestos was detected by the analysis in ISO 22262‑1; b) resilient floor tiles, asphaltic materials, roofing felts and any other materials in which asbestos is embedded in an organic matrix and in which asbestos was detected when using ISO 22262‑1; c) wall and ceiling plasters, with or without aggregate, in which asbestos was detected when using ISO 22262‑1. If non-asbestiform serpentine or non-asbestiform amphibole minerals are included in the matrix, the XRD peaks that are assumed to be "possible peaks of asbestos" will represent these minerals. This method is not for application to natural minerals that may contain asbestos or any products that incorporate such natural minerals. This method is intended only for application to building material samples that contain deliberately added commercial grade asbestos including tremolite asbestos. ISO 22262-3:2016 is intended for use by analysts who are familiar with X-ray diffraction methods and the other analytical procedures specified in the References [5] and [6]. It is not the intention of this part of ISO 22262 to provide basic instruction in the fundamental analytical procedures. |
국제분류(ICS)코드 | 13.040.20 : 대기 환경 |
페이지수 | 45 |
Edition | 1 |
No. | 표준번호 | 표준명 | 발행일 | 상태 |
---|---|---|---|---|
1 | ISO 22262-3:2016 | Air quality — Bulk materials — Part 3: Quantitative determination of asbestos by X-ray diffraction method | 2016-10-05 | 표준 |
ISO/DIS 22262-2 - Air quality — Bulk materials — Part 2: Quantitative determination of asbestos by gravimetric and microscopical methods 상세보기
ISO 22262-1:2012 - Air quality — Bulk materials — Part 1: Sampling and qualitative determination of asbestos in commercial bulk materials 상세보기
ISO 22262-2:2014 - Air quality — Bulk materials — Part 2: Quantitative determination of asbestos by gravimetric and microscopical methods 상세보기
ISO 23431:2021 - Measurement of road tunnel air quality 상세보기
ISO/TS 20593:2017 - Ambient air — Determination of the mass concentration of tire and road wear particles (TRWP) — Pyrolysis-GC-MS method 상세보기
ISO 20305:2020 - Mine closure and reclamation — Vocabulary 상세보기
ISO 22262-2:2014 - Air quality — Bulk materials — Part 2: Quantitative determination of asbestos by gravimetric and microscopical methods 상세보기
ISO 16000-27:2014 - Indoor air — Part 27: Determination of settled fibrous dust on surfaces by SEM (scanning electron microscopy) (direct method) 상세보기
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기